Interested to Buy Any Domain ? << Click Here >> for more details...
Where -48 volt DC use & why?????????
- 10 Answers
- 31963 Views
- Ericsson, INDUS, Indus Towers, Telecom, I also Faced
- E-Mail Answers
Answer Posted / maxiquiet
why do we prefer -48 volt instead of -24volt or -12 volt
etc. ??
| Is This Answer Correct ? | 5 Yes | 4 No |
Post New Answer View All Answers
What is trip and closing coil in cb? Why need of them
How does an induction motor start?
I want to know Electrical Circuit?
What is the difference between circuit breaker and isolator
What is tan delta & PPM in transformer? and whats its IS value?
Why Neutral Isolation is required?
How can eliminate noise problem inside temperature controller temp. variation due to contactor chattering problem.
How to calculate per unit impedance of transformer?
Dear friends, i would like to know that what is the exact function of 'exciter winding' & 'aux winding' in Alternator?
Is there any type of starter for DC motor other than two point,Three point and Four point starters?
ANY ONE TELL ME ABOUT generator synchronization panel panel to synchronise 3 gen of 250kva both automatic and manual. 2 gen output vol 415 3ph, 1 gen output vol 400 3ph SEND THE DETAILS DIAGRAM ON THIS EMAIL ADDRESS ayazleo@hotmail.com as soon as possilble best ragrds electrical engineer ayaz mahmood SAUDI TECH
Can you explain about Restricited earth fault protection scheme
what is the principle of operation of tungstun bulb ??
all the technical question with answers pleas send your email id ramar_eee@yahoo.com
sir please tel me how calucalte kwh if home taken load 30ams how maney kwh taken per day.and 3phase motor 5hp per hars how maney load teken and how mach kwh and forward me to electrical table for calicalte kwh and kvr and kvah
