Interested to Buy Any Domain ? << Click Here >> for more details...
What are the possible causes if load is not same on all the
three phases
- 4 Answers
- 6215 Views
- I also Faced
- E-Mail Answers
Answer Posted / srinualn117
The possible causes of unbalance load
1.resistance / ph of the winding
2.reactance / ph of the winding
3.volatage value of three phases
| Is This Answer Correct ? | 0 Yes | 0 No |
Post New Answer View All Answers
Safety of dry type transformer
defination of lines
What is a difference between indoor transformer and outdoor transformer of same rating
comparision between ACB and VCB
Define bibo stability.
Post possible questions for Power Factor Panel FAT / SAT
how open delta PT works & what is its construction?
In the N-series schneider reclosers. What is the difference between current during fault time and current at tripping? This appears in the Event log in an event of a trip out.
at work we have a 3 phase motor but on testing one phase isnt getting a reading. it runs 24 hours a day all week. stops and starts well no noise or heating. the phase isnt down to earth.is it just a bad meter reading or not? phases one and three came up with a resistance reading of 0.4 but phase 2 couldnt get anything shows up as open circuit.
HOW THE OLTC TRANSFORMER SAVE ENERGY IN COMPARISON TO OFF LINE TRANSFORMER AND IS IT ECONOMICAL TO REPLACE THE OFF LINE TRANSFORMER TO OLTC TRANSFORMER
What is the importance of earthing?
How do i perform grounding of star point of Genset (400V) for making connection with step up transformer of DELTA-DELTA (400V to 20KV) ? while Genset itself has its own neutral and grounding bus bar inside genset breaker box whereas we have another neutral and grounding busbar in synchronizing panel next to genset at maximum distance of 6meter, would someone pls advice if we can only perform neutral grounding in synchronizing panel or should we ground neutral on both places inside genset breaker box and synchronizing panel.
What types of CMOS memories have you designed? What were their size? Speed? Configuration Process technology?
How to calculate MCB Breaking capacity.
anyone please send transformer parameter design formulas & details of tap changer ? plz i have interview this week its more helpful for me ?
