How to solve the problem of low voltage at consumer end in
distribution system if one phase come low voltage of
transformer

Answer Posted / k.prakashchandra

Replace the tr if faulty or change the supply phase

Is This Answer Correct ?    1 Yes 0 No



Post New Answer       View All Answers


Please Help Members By Posting Answers For Below Questions

what is the main difference between power devices and signal devices

1701


In siemens S7-300 PLC, what is function and function block ? What is the difference between them ? When to use function and when to use function block ?

1649


How to know vacuum in vacuum cylinder of breaker in working condition

1509


Give some differences between open loop and closed loop?

639


Is a contactor (or master relay) required between incoming lines and a VFD? The question goes to safety. If a contactor were used before the VFD and an e-stop engaged then the motor will coast to a stop (i.e. VFD loses power) instead of stopping much faster if the VFD braking fucntion were used. It would make more sense to keep power on the VFD.

1563






sir i am apearing for nic exam.i dont know exam pattern.can you please send me some model papers

1505


what is the VA(Volt-amphere)? define with calculation?

786


why core is useful for a transformer ?and also in its operation ?

1586


sir i have a car stereo system and there is jack on him so can u tell me a way to find out their power terminals on the jack or on the circuit board"

1568


How should i design a 1ph & 3 ph transformer. Kindly let meknow all steps and formulaes related to design from scratch.

1526


what is mean by kneepoint voltage? when it will happen? ( my doubt is, if CT secondary is open means ct get saturation or blas? what are factors are required for calculations? plz give currect anws:

1535


What is the meaning of Insulation H for transformers????

1620


is there any current and voltage drop on liquid resistance starter water/soda tank ?

1491


what is counter poise conductors

1682


In the N-series schneider reclosers. What is the difference between current during fault time and current at tripping? This appears in the Event log in an event of a trip out.

1342