Interested to Buy Any Domain ? << Click Here >> for more details...
what is the significance of pressure angle in spur gear?
What is meant by self locking in worm and worm gear?
- 11 Answers
- 50529 Views
- I also Faced
- E-Mail Answers
Answer Posted / asma aslam
pressure angle in gear set is defined as the angle between
the line of action (common normal) and the line
perpendicular to the line of center.pressure angle rotated
in the direction of driven gear.
Significance:
increase of pressure angle
1-reduction in the danger of undercutting and interference
2-reduction of slipping speed
3-increase rigidity of toothing
| Is This Answer Correct ? | 8 Yes | 6 No |
Post New Answer View All Answers
why is heat treatment of steel metal crucial?
Hai, iam renjith. my qtn about the calorex heat and cool pump. What is the reason of the above machine is trip on high pressure. r134a gas using in this system. 8 months old. model is calorex propac 90(3 phase). This system has 2 compressor. Both are starting on 13amps after that rise up to around 21 within 1 minute. After will be trip on high pressure. Showing 68 psi in suction side on standby mode. Can i have a solution without delay? Renjith renjithngm@gmail.com
What causes a hydraulic cylinder to skip?
should cutouts made in main header of metal ducting be deducted from duct measurement.
What causes turbocharger surging?
Why should a chain drive be used over a belt or rope driven drive?
The graphite in grey irons exists in the form of flakes which act as stress-raisers under tensile loading and consequently grey irons have relatively low tensile strength and ductility. Still grey iron is extensively used in engineering. Why ?
What are the advantages of powder metallurgy?
Sketch the jacket cooling system?
WHAT IS THE DIFFERENCE B/W LUBE OIL 20 W 40 AND 20 W 40 OIL.
If anybody have the ref. design book of the 3 point cylindrical rolling with sheet thickness of 2.3 mm & 67 mm internal diameter legth of 80 mm
how to calculate bearing pre-load?
What are the thermal conductivity properties of brass?
How is propeller fitted in shaft?
Explain how do you calculate cooling energy?
