Answer Posted / eng.walid rezk
there are two main functions
1- to store the hydraulic energy into potential(pressure)
energy to use during an interval
2- i ca use it with the low flow rater pumps when large
amount flow flow needed during an interval of the hydraulic
cycle
3- it used to remove the pulsation of the pump operation
4- it works as a shock absorber to absorb the sudden rise of
pressure if an error or problem happen during working and
that's all
| Is This Answer Correct ? | 3 Yes | 0 No |
Post New Answer View All Answers
effect of temperature on stainless steel,aluminized steel,chromium at (500C-750C)-required for project work on silencer 1.thermal conductivity 2.heat conduction 3.mechanical strength 4.temperature to weight ratio urgent
How to find DG efficiency and unit per litre
Explain in an orderly manner how the force in the member of a truss be detected using the method of joint.
Quantities like pressure, temperature, density, viscosity, etc. Are independent of mass. What are these called ?
how hydraulic power stearin clutch work plz explain
What are the advantages of gear drive?
pleas send me the syllabus of rrb je examination(mechanical)
what is the procedure getting road permit form online
tell me about a time you were able to successfully deal with another person even when that individual may not have personally liked you or vice versa.
Define pitting.
T union support factor
about basic questions ofpiping engg
What is acceleration
What are the protections in a Diesel generator Engine?
draw IRON-CARBON diagram.
