Why would an Engineer consider combining FEEDBACK and
FEEDFORWARD control in some applications?
Answer Posted / gonzales
In boiler when tripple element controlling required
| Is This Answer Correct ? | 4 Yes | 2 No |
Post New Answer View All Answers
For crude application in floating roof tank, how to calibrate a DP Transmitter? How is the floating roof weight considered?
what is piezoelectric transducer?give an example in power plant n state its principle?
why we are using digital signals for I/O & how to measure this signals is getting or not ?
pls suggest suitable MOC of diaphragm for pressure measurement of UREA grade solution service fluid.
How to regulate the flow of Air in 4" line, with max flow of 330 nm3/hr and Pressure of 0.5 bar? please suggest the type of instrument required.
How to change dcs card in online. (Dsc is maxdna)
what is the field bus calble ? what are diffrences in orang colur cable and black coular calble ?
What is cut off relay? And why use in PLC and DCS?
We Have Two Field bus Pressure Transmitters of Different Sensor Range (I.E One is of Lower range and Another is of Higher Range).Is same Process Line. My Question is Can i provide Saturation Limit to my field Bus Transmitter as We can provide Saturation current limit to HART Instruments. As During Low Pressure Both Working OK ,But During High Pressure, transmitter with Lower sensor range Goes to Fault mode as Beyond its Sensor Limit it can Measure, So may I provide Saturation point Some where to Suppress This Fault during High Pressure.
what is the reset offset and control system in instrumentation
What is modbus?
HOW CREATED LP & HP PRESURES IN DRUM FOR DRUM LEVEL MEASUREMENT!
What is the use of each wire in three wire RTD
What happen if we install my pressure transmitter below the elevation of pipe in natural gas service?
How to do gas analysers calibration in AUTO and Manually by using zero and span gas?