Interested to Buy Any Domain ? << Click Here >> for more details...
Answer Posted / badal randar
Strainer is usually used before the prime mover,and filter is usually used after prime mover.........
| Is This Answer Correct ? | 0 Yes | 2 No |
Post New Answer View All Answers
While normal carburising and nitriding surface treatments increase fatigue strength, excessive treatment may decrease the fatigue strength. Why ?
I need BHEL apptitude questions
We have 6-axis wotan horizontal milling & boring machine. Linear axis- x,y,z,w & U. Rotary table B Axis Z,U & W axis are parallel. Z is tool axis. X is cross slide. We wish to retrofit the machine.Which control I should select & also suggest How many axis simutaneous control for linear & circular interpolation.
i need iocl model aptitude question papers soon as possible .so pls 4wd it to m id akakil1820022gmail.com
Why PWHT IS NOT DONE TO STAINLESS STEEL MATERIAL?
sir i am selected for HAL Ast. Engg so pls Interview Qus
Why cad cam is better field against IT field?Is the salary is good in this field and if it so then what is the average salary in this field because I don;t think that salary is good enough in this field.
What is higher IMP or BHR
what type of question has been asked at schwing stetter
what will be the min curvature ratio for Round Bar dia. 1” size in material grade AISI 4330, Yield strength 115KSI Tensile 140KSI?
why does bitumen heated from top side bt not from bottom side€
Wasco Interview 1-the type of transducer that convert mechanical movement into a voltage 2-pump 2500 psi and 100 MG select it 3-modes of heat transfer 4-the difference bet PSIA and PSIG 5-the function of relief valve and no return valve (check valve ) 6-types of bearing general catogires 7-function of bearing 8-compressor surge 9-pump cavitation 10-define critical speed 11-compression ratio decease volumetric ratio ........... 12-using inter-cooling in multi stage compressors to ....... 13-using cascade system in refrigerator function ? 14-define performance and efficiency .
My vendor filled liquid oxygen in our 11000 liter capacity tank. He filled from 1400 MMWC up to 3200 MMWC. I followed the provided conversion table and found that we had been supplied 1800 MMWC liquid which is going to yield 2815 cubic meter. On the other hand, the vendor claims that he supplied as follows:- 5236 cub mtr(3200 MMWC)-2124 cub mtr(1400MMWC) = 3112 cub mtr. I fear that he wants to charge 297 cubic meters extra. He claims that my method was wrong and his was right. He says that this disparity is because of the conical shape of the base of the flask. I will be thankful if somebody can explain me the truth.
i want to know how a dg set run/works and what is strock and what difference in between two and four strock engine.
What do you mean by annealing?
