what is mant by point of conter of fracher(p.c.f)
- 6 Answers
- 7997 Views
- TCS, I also Faced
- E-Mail Answers
Answer Posted / vijayakumar.s
The point where Bending moment chenge its sign(ie.+ to -)
in other words the point where BM becomes zero.
| Is This Answer Correct ? | 19 Yes | 0 No |
Post New Answer View All Answers
What is the bowing depth after stressing of PSC Girder of various spans and various dia of strands?
What is the effect of a building collapse?
what is yield and tensile strength of steel, if steel has yeilding strength of 60 psi than how much its tensile strength?
How to build the floor to ceiling bookcase?
If we are providing concrete joint in every 10m with water stopper in water tank wall then is it necessary to cut the steel at joint section?
How much cement,sand,bricks and water needed for 1square metre brick work?
how to do cementicious paint for rcc walls of cw pump house
Is it necessary to apply tack coat over the primecoat. IF not what happens.answers other than 1.to superimpose the next layer(2) to adhere the layers so as to form homogenity.
Describe the sections included in a typical bill of quantities
What is the use of water table & Kreb stone for drain
What are the reasons for geotechnical site investigations in uganda?
what is the basic difference between Coloumn & Shear Wall
primary treatment of sewagw consist of removal of floating materials removal of sand & grit removal of organic materials all above
Can you pl explain the procedure steps of singly and doubly reinforced beams in limit state method
Curing time for 1)R.C.C slab 2)B.W 3)Plastering
