Answer Posted / anand
RC
| Is This Answer Correct ? | 2 Yes | 1 No |
Post New Answer View All Answers
What is meant by load angle of an alternator? Upon what factors does the load angle depend?
diff b/w elcb and rccb
WHAT IS DIFFERENCE BETWEEN MANUAL CONTROL AND MAGNETIC CONTROL AND STATE ITS ADVANTAGE /DISADVANTAGE
Can u Explain about the electronic trivector meter and the use of data converters in them?
In Air circuit breaker LSIG protection unit is used. Without fault in cables (2 runs 3Cx150Sq.mm Copper, 1Kv grade, XPLE armored cable IR value is more than 550Mohm @ 500V Megger) and load section Long time Overcurrent protection is triggers and trips the unit. We changed LSIG protection with new factory tested unit. Even then fault is persisting. Please suggest the possible causes
Why strting torqe high in inducation motor?
Is there any Electrical supervisor license which gives permit to work whole India rather than individual state??
suri transmission
WHY THREE PHESE SYSTEM VOLTAGE APPLIED IN 440 VOLT
difference between Ac and Dc mcb ????
how to calculate fault level?
What is Annunciation?
How can we convert 11 kv to 440 volt without using transformer ?
Atwhat condition reverse power relay will act?
how to setting Load amps tripping time and extra settings for load Transformer protection relay with RMU panel using C&S model relay..?
