i have a wire.and the current flowing in that.when we cut
the wire then why dont we seen the elactrons....
- 8 Answers
- 10189 Views
- GM General Motors, I also Faced
- E-Mail Answers
Answer Posted / admin
when we cut the wire
further any flow of electrons stops,electrons dont flow out of the wire they rest at their instantenous position inside the wire
| Is This Answer Correct ? | 0 Yes | 2 No |
Post New Answer View All Answers
why power factor is important?
what is photo voltic cell,& what are the materials associated with that?and any spcifications like volts/cm etc?
What is the angle of inclination for the oil connection from transformer conservator to Bucholz relay and why?
what is the range of maximum DOL and SDS can be use for pump and fan application
Why air circuit breaker off due to power failure?
What is the lockout relay
how much value of resistance should connect to 15 kw, 6 pole 3 phase slip ring induction motor having RV-240, RA-42.
what is servo motor & how does it work.
Form S and "c" license application both are same? @ tneb portal
how copper and aluminium wires or cables are choose for current rating? please provide copper and aluminium wire selection chart for different current rating ?
when generator short circuit condition, the current how dissipates. or at short circuit voltage not available then current how can flow?
what is negative and zero impedance in 3 phase induction motor ??
if two transformers are placed parallel & both have fault impedance of 50KA will it increase or decrease show example?
wow to calculate the transformer rating(KVA)
If i have two 3000 kW motors and the whole facility requires a 10 MVA transformer. What would be better installing two 5 MVA transformers(one for 1 motor ) or just a single 10 MVA transformer for both of them. Give reasons for your answer.
