Interested to Buy Any Domain ? << Click Here >> for more details...
if we use contactor & MCCB both in a feeder.in this feeder
rating of contactor is higher or lower or same of MCCB
rating & why?
- 1 Answers
- 3659 Views
- I also Faced
- E-Mail Answers
Answer Posted / k.prakashchandra
It is of no use if the settings of both is the same.The one
nearest to load should have a lower setting.
| Is This Answer Correct ? | 0 Yes | 1 No |
Post New Answer View All Answers
May I know how much values to be set for earth fault, over current and short circuit values at 11kv side? I have 11kv van 1250amps rating. Present it's taking load 80amps?
I want to know Electrical Circuit?
What are the various types of rotor used in the alternators?
How can we checked Killo Watts of Motor & Alternator?
BRIEFLY EXPLAIN THE STORAGE CLASSES AND THEIR TYPES IN C
If an electrical component has a positive temperature coefficient, how come such components have high power losses due to heat if current decreases when resistance increases? assuming power given by I^2*R whereby the Resistance is infinite.
lenz law application and define
how can i reduce sparking without stepdowning the voltage
Draw torque - speed curve and load curve of induction motor? mark operating point ?
What are the symptoms of a bad PG card of a drive (inverter) esp. of Yaskawa Ac Drives (inverters) G7 ?
electrical
An 8 pole, 50 Hz, 3-phase IM is loaded to a poing where pull out torque will occur. The rotor resistance per phase is 0.3 ohm and motor stalls at 650 rpm. The rotor reactance at stand still is A 2 ohm B 1.25 ohm C 3.15 ohm D 2.25 ohm
during installation time of transformer and alternator which points we have to observed?
What is the meaning of C1, C61, C91 cable
How to calculate capacitor bank value to maintain unity power factor with some suitable example?
