Answer Posted / k.prakashchandra

No and it will not be of any help

the site measured knee point voltage of protection class CTs should be greater than rated knee point voltage? what about meetering class CTs. Should it be below the rated knee point voltage?

2281

---

Suppose a 3 phase, 2 pole, 440V induction motor is driving a flywheel of 600mm diameter, 150kg mass. By using v-belt and pulley, the speed is increased to 4500 RPM. What will be the effect on motor current?

1408

---

Assuming that a dedicated neutral earthing transformer is provided for each GT generator, when the two generators are running in parallel, has consideration been given that the earth fault current from one generator stator winding be split between the two neutral earthing transformers? If so, what adverse impact will this have on the operation of the 59N and 27TN devices?

1658

---

List out the different frequency domain specifications?

1235

---

in control panel, how can i measuring the distance between one bus bar to another bus bar. then now only for bus bar. in mpcb and contactor also. that means one mpcb to another mpcb how much distance? how can i calculate that.

2378

---

how to check avr of dg set of 125kva

2601

---

what is active power & reactive power?

2191

---

what happen if generator of micro hydro running at only a small percentage of its capacity, as a comparison, if the diesel generator that runs on only a fraction of its capacity there will be a wet stacking

1944

---

Can u tell me design of switch yard

2175

---

what are the difference between PLC and embedded

2151

---

what is differnce btwen lll and lllg faults

2017

---

what ispositive, negative, zero sequence impedence?

2030

---

Explain cos(theta) and Sin(theta)

2112

---

exolain the star delta connection

2680

---

In ups static switch if i gives the supply at output end it will open the circuit in stactic switch or not if it will open then how it operates.

2311

---