Answer Posted / patel_rakesh2089@yahoo.in
power factor is the cosine angle between voltage and current.
| Is This Answer Correct ? | 8 Yes | 2 No |
Post New Answer View All Answers
How could a garment factory benefit from renewable energy
Earth leakage relay basic knowledge principle
we use capister for power factor. when we use capaciter in dg circuit than defect dg. can we use capaciter bank for dg circuit
what is the preventive maintence for ht panels and busbars and vcb abd acb's.
What is the equivalent circuit of a transformer and its vector diagram?
bus bar design conditions and sizing pls tell me quickly
why should the lowest unit of a testing transformer ( cascaded transformer ) have higher power rating??
Which are resistive loads & which one are inductive loads : Refrigerator, Split air conditioner, ceiling fans, well pump, fluoresecent bulbs, T.V, CRT Monitors, Adsl Routers, C.P.U, Printers, Deep Freezers, Speakers, DVD Players, Microwave oven etc. ? Output Power for these Appliances Would be same like this : P = V * A * P.F Or would be changed ? thanks
what are the applications of PLC?
what is Fault level? why it is calculated? how will u decide same for our plant?
Give the expression for the frequency of oscillations in an op-amp sine wave oscillator?
Why derivative controller is not used in control systems?
what is apparent poewr, reactive power, & active power?
I meggared my 2c*70 sq mm AL AR XLPE cable. its one end show 50 M ohm . is my cable is safe for laying. I have only one phase and neutral.
How to arrange a hous hold earthing system to keep minimum earth resistance( below 7ohms).