Interested to Buy Any Domain ? << Click Here >> for more details...
what is the use of megger? and types
- 11 Answers
- 57755 Views
- TNEB Tamil Nadu Electricity Board, I also Faced
- E-Mail Answers
Answer Posted / n rajesh
Megger is used for measuring insulation resistance and
measuring high resistance.
| Is This Answer Correct ? | 44 Yes | 6 No |
Post New Answer View All Answers
I am getting above 60 V as open delta voltage against single phase unit ICT at tertiary delta formed and ICT getting trippped on NDR. ICT tested and found in order. PTs provided on tertiary are tested and in order. what may be the reason?
if two transformers are placed parallel & both have fault impedance of 50KA will it increase or decrease show example?
HOW TO WRITE A QUENTION ANSWER? I MEAN SHORT OR LENGHTHY ? OR FROM THE BOOK AS BOOK..... SOME TIME WE GIVE A ANS FROM THE BOOK AS LIKE BOOK ND WE GET MINIMUM 60% MARKS OR MORE THEN....... THEN HOW TO FILL THE Q-PAPER?
Power Factor Correction Panel (Manual & Automatic)
how to calculate the mesh earth network resistance in such substation, is there any recommended resistance values with references , thanks!
dg started in plc mode and load taken later one battery terminal connection will be disconnected by loose connection what will happen for dg and shall we connect battery terminals while dg in load time?
What is the role of feedback in a closed loop control system?
wish of these transformer uses oil?
Explain difference between stand by earth fault and residual earth fault protection?
How to calculate the electrical load for a standard telecom BTS shelter and choose the DG set capacity for the same load?
what is the difference b/w pvc cu conductor and cu breaded wire..?
we have 15 ampere variyac but we want 30 ampere variyac what we do
what are the difference between AC lamp and DC lamp
What is meant by reset level of the relay?
WHY RATING OF VCB NOT LESS THAN 630A
