If two hack saw blades, seperated by 1mm thick paper,are
connected across 230volts, and immersed in water,then they
start getting heat. This is fact,i dont know how they get
heated.Blades are not directly connected together.
Please if anybody knows the fact ,revert back to me
- 3 Answers
- 4092 Views
- I also Faced
- E-Mail Answers
Answer Posted / k.prakashchandra
Water acts as a resistor.
| Is This Answer Correct ? | 0 Yes | 1 No |
Post New Answer View All Answers
What do you mean by per capita requirement of electrical energy in india
How to calculate size of HT breaker with the help of Amp (current)? Please provide answers with examples.
In our factory so many iron pillors are exists for supporting the shed/Hangar. If do more no of earthings at one piller instead of doing more earth pits in many locations and running earth strip around the hanger, I can save the money. Please suggest this method is acceptable as per Is specifications though the Earth resitance of the farthest piller is with in the limits as per IS specifications.
how to calculate the step resistance for slipring induction motor,how you deside the no of step for that?
Could u pls tell me the NPCIL electrical engineering interview questions for Executive trainee, and also guide me how to face the interview.
why +24 v and -48 v give to BTS? If -48v protect from surge then why we not use -24 v?
How can I model an open-delta ground transformer for a network supplied by 4 unit GTG and power transformer in ETAP?
what is meant by poly phase induction motor ? how its operating by single phase or three phase?
can we choose current transformer secondary, to calculate residual flux in a power transformer, so as its saturation is close to the saturation level of power transformer?
Difference between low impedance and high impedance Restricted Earth Fault
we use capister for power factor. when we use capaciter in dg circuit than defect dg. can we use capaciter bank for dg circuit
for compensate 315mh inductance ,how many capaciance required?
HOW TO CALCULATE THE HEAT AND LOAD OF LT-SUBSTATION WHICH CONTAINS 2*1MVA TRANSFORMERS,LT-SWITCH BOARD,MLDB,ACB,BUSBAR,ETC,......?
I Have 3 Phase 10 KW AC Alternator i found one phase weak, so what will be the reason & what action shouls i take to rectify the same.
FEINGING DECREASES THE FLUX DENSITY IN THE AIR GAP. HOW?
