Answer Posted / k.prakashchandra
The front portion of the panel consisting of meters is
called the panel board.
| Is This Answer Correct ? | 0 Yes | 0 No |
Post New Answer View All Answers
How to control motor gearbox speed and friquency? If length of cable and dia given, how to measure the voltage drop?
if a.c supply is given to the motor,, what happen?
what is the minimum winding resistance of 30hp compressor, to run or to switch on
What is meaning of out of phase (making & breaking) capacity And how to calculate
When we use air circuit breaker, it has O/L protection ,time delay SC protection, Instataneous SC protection & ground fault protection. They all have some setting range. But what is the suitable/allowable setting for the above protection which will be safe for the equipment? For example-O/L protection setting have a range of (0.4,0.45,0.5,0.55,0.6,0.65,0.7,0.8,0.9,1.0)xIn Time delay SC protection have a range of (1.25,1.5,2,3,4,6,8,10,12)xIn Time delay setting is 0.02,0.1,0.2,0.3,0.4 Instataneous setting is fixed to 20xIn Gound fault setting is given 100A,300A,600A,900A,1200A This setting are for 2500A ACB. So what will be the basic allowable setting for the above protection? is there any formulae to calculate this<
why in an industry; machine having rated 200 h.p stopped after power factor is maintained above 0.97 lag by control panel in view-of energy saving
Safety of dry type transformer
We are designer please help me calculate the size of 11kv cables from step up transformer to M.V panel, total load is 5 mega watt distance 900 feet (used aluminum type cables) please provided formula for calculate the cable with example.
What is the Temperature to be set in Thermostat provided in Marshalling box of the Transformer / Motor.
why normally Generator rating are between 11Kv to 22Kv?
what is the difference between ups & inverter
What is the difference between diesel generator engine with and without turbo charger with the same capacity?
Damping resistor provided in open delta (tartiary) winding of a measuring PT at the incoming of a MV inverter drive panel is getting heated up. Can any body explain the reasons and suggest the remedy?
What is Control & Relay Panel? And Remote Control Center?
How will A Medium voltage circuit breaker(11 kV voltage level) operate under short circuit fault condition whether It is having short circuit release like Low voltage circuit breaker or relay should be given?
