How do you select a cable size(Cu&Al) for a particular load
- 10 Answers
- 30596 Views
- Adhunik, BPCL Bharat Petroleum, Hiecon, TATA, I also Faced
- E-Mail Answers
Answer Posted / rahul singh
wire size is depend upon the type of wire.
if we used the CU wire then the size of wire should be the 1/5 part of load current and AL wire wire will take around 1/4th of the load current
| Is This Answer Correct ? | 2 Yes | 2 No |
Post New Answer View All Answers
what is the effect of un-synchronized power.
What are high pass filter and low pass filter? and What are the flowmeter ?
State norton’s theorem?
how to setting voltage RTCC panel
What are the commonly used schemes for the bus zone protection?
how to calculate kvar in Akiva
I WANT YHE TECHNICAL AND ELECTRICAL SPECIFICATIONS OF 2x4MW 11KV 2x10MW 11KV 2x25MW 11KV 2x100MW 11KV HYDEL POWER PLANT i.e PROTECTION SYSTEM,MONITORING,CONTROL SYSTEM,GENERATION,SYNCHRONISATION,METERING PLEASE SEND THE DETAILS TO MY MAIL ID SPRAVEEN_222@YAHOO.CO.IN
what is capacitor voltage transformer?? how it is different from potential transformer?
how we can do the insulation on secondary of ct explain and so that tan delta will within limit
how we explain parallel paths armature winding?
a simple c++ program to calculate simple interst with its data members as private
What is referred to the electron in the outer orbit?
What is safety of Ht panel
what kelvin's law ?
In a tap changing transformer where is the tap connected, is it connected in the primary side or secondary side?
