how to select a capacitor,
i mean we use 3.5 mico ferad cap for a celling fan,but how to
select a cap for 1h.p motor,etc.........
- 1 Answers
- 3185 Views
- I also Faced
- E-Mail Answers
Answer Posted / sanjay kumar
42 micro ferad
| Is This Answer Correct ? | 0 Yes | 2 No |
Post New Answer View All Answers
why and where we use early make & late break contacts in protection?
What is mean by spike arrester(Voltage Operated)
how we can adjust for three phase motor cold stall time ,hot stall time and thermal register set up?
Maintenance of transformer???
any body,pls tell me how to done relay coordination ? how to coordinate by TCC curve?how to read the tcc curve?
explain the functions of main isolation switches
Explain the different regions in frequency response?
What is the need of earthing transformer for delta side of a transformer. (Think of a line section between a star/delta transformer at a grid substation and delta/star transformer at a village. An earthing transformer is there at the delta side of the star/delta transformer at grid substation). As there are no ground reference there will not be fault current if a one phase is grounded. Further L-L phase will be sensed by the primary side of star/delta transformer as a L-G fault. So why an earthing transformer is required at delta side
An 8 pole, 50 Hz, 3-phase IM is loaded to a poing where pull out torque will occur. The rotor resistance per phase is 0.3 ohm and motor stalls at 650 rpm. The slip when motor stalls is A 1 B 0 C 13.33% D 10.33%
How to calculate wire length,size & current? ( related to control panel)
Why air circuit breaker off due to power failure?
1. The DC generaror,s induced output emf is connected with a DC motor(as load). when increasing the load of the motor by using brake drum or any way. what are the parameters will changes in both motor and generator(voltage, current, resistance, frequency, speed, torque, power, flux etc...) 2. Similarly for AC generator and AC motor 3. similarly if using DC batteries instead of DC generator, What happens?
What is the basic principle of operation of alternators/dc generators?
placing earthing pit in pathway is correct or wrong??. placing earthing wireGI1/18 inside walls is correct or wrong?. explain!!!
I have two PLC processors. I want to communicate both processor with each other. How i can do so?
