Answer Posted / shimla
HT breaker is like a switch only which we use to break and
make the supply (more than 415V) according to the
requirement.It use to be installed before transformer. It
has some extra safety as compair to other switches.
| Is This Answer Correct ? | 13 Yes | 16 No |
Post New Answer View All Answers
How to design the earth grid for lightning protection in an industry
How many turns are there in primary winding? (In Transformer)
Why are cables rated for 40 KA for 0.25 Sec fault current rating?
A 3-phase IM is supplied from 50 Hz system. It runs at speed of 1440 rpm and slip equal to 4 %. Calculate number of pole pairs. A 1 B 6 C 2 D 3
Actually I have a doubt on neutral and earth.we use Ac power without taking neutral by connecting to earth,but at that time does it affects on efficiency of any electrical components or no? If yes how?
Is there a standard depth of gravel fill in Substation Switchyard? Please give a design/drawing. Thank you.
In a 3 phase 4-wire system. For a 3.5 core cable if all loads are single phase and balanced, what will be neutral current? will it be sum of all phase currents? Or it will be zero? And if loads are unbalanced what will be neutral current?
How calculated single phase induction motor req. Capacitor?
what is self capacitance of inductor
what's the requirement of Dy11d0 connection of 3 phase transformer?what's use of it?
1. Why is the speed of shunt motor practically constant? 2. Why dc series motor use to start with heavy loads? 3. advantages & disadvantages of separately excited generator over self excited generator?
I need to connect a synchronous generator to the grid using automatic synchronization and two circuit breakers (one for synchronization, one for end connection to the grid), how to determinate the required diameter of the cables?
If ROC does not lies inside unit circle,then ? a) Fourier transform converges b) Z transform converges c) Hatly transform converges d) Colpit Transform converges.
acb(AIR CIRCUIT BREAKER)NOT CHARGING AUTO
