Interested to Buy Any Domain ? << Click Here >> for more details...
Answer Posted / k.prakashchandra
By simulation
| Is This Answer Correct ? | 0 Yes | 1 No |
Post New Answer View All Answers
1) Explain why we don't link the two earthing system ht and mv on a pole mounted transformer sub-station.
how can i use REF and diffrencial relay both in 1 CT core for transformer protection?
How many double suspension hardware fittings are required on a double circuit transmission tower?
Air refrigeration cycle works on the
we have earthmat at 110KV substation.we would like to take earth resistance.b some says that by connecting earth megger terminals (C1,P1) at middile point of earthmat (at riser) will cause voltage gradient at other earthmat nods and dont get exat earth resistance.when connecting at end nods will get exat value . is it correct .please explain
What is the formula to calculate the no load current of a single & three phase induction motor
What is the minimum distance to be maintained in between HT panel and LT panel and Instrument panel as per IEC and NEC standards?
how does high earth to neutral voltage affects electronic circuit?
What happen when neutral point connected to core balance current transformer? (Neutral point of an alternator of a 180KVA DG. Neutral point connected to CBCT means enter to the CBCT)
66kv under ground cable how to layaing in ground any special case two ckt r runing
What is servo motor and what are the applications of servo motor?
What is the minimum value of hfe for the oscillations in transistorized rc phase shift oscillator?
What information we need to prepare relay coordination chart
How many types of circuit loads are there in a common electrical circuit?
We have 250 KW x 2 motors, which are load from 25% to 100% varying load in every minute , so how can we compansate the power factor. pl give your opinions on the above subject.
