Interested to Buy Any Domain ? << Click Here >> for more details...
can we run all LT motors at 360 volts which are normally
rated 415+/-10% voltage rating
- 2 Answers
- 4142 Views
- Meinhardt, I also Faced
- E-Mail Answers
Answer Posted / bala_vlsi
No, because we can achieve the recommended motor torque
at 415 V+/- 10 % level only (torque is directly
proportional to the current (P = I²/R) If the torque is in
low condition, required more current for try to achieve
the specified torque so automatically the motor will
generate more heat and motor will be damage / burn .
| Is This Answer Correct ? | 9 Yes | 2 No |
Post New Answer View All Answers
do anyone out there know where to find a compleete list on acronyms/abbreviations used in offshore electric engineering. MCB - Micro Circuit Breaker, MCCB-Mouldes Case Circuit Breaker, ELCB-Earth Lekage Circuit Breaker, ELMCB- etc.....
Circuit diagram of tube light without starter using electrical choke
-What should be minimum value of insulation resistance and maximum value of earth resistance at any electrical instillation and what is method of testing the same.
What should be the percentage increase in length of the dead end clamp for bus bar conductor (Hawthorn) after hydraulic pressing and what should be the applied pressure?
Whether amorphous core transformer is available in India?.If available then up to what rating of voltage and KVA?.
How I calculate the ELCB for circuit breakers?
Why the magneti fields are not passes from southpole to north pole
what is the best method of grounding in 30 MW generator?
please give me all the Alarm .Trip ,Safety Relays & Conditions of Diesel-generators mail me on ashokbabunhce@gmail.com
what happen as when voltage drop(or may decrease) ? in case of atomic base theory?
in control scheme dc logic wiring commonly using negative loop,what is the reason?if we use positive looping what will happen?
If a surge divertor is required to be protected by 32 amp C Curve Circuit breaker does this limit the amount of protection from surges that you will acheive
why Y CONNECTION IS BETTER INTERMS OF EFFICIENCY AND P.F FOR A LAOD LESS THAN 40% AND WHY AFTER DELTA IS BETTER FOR > 40%
when ID fan will immediately stop through VFD what exactly cause and problem the ID fan
how to select the mpcbs and contactor for 3 phase 30 hp star delta motors.for plc control.and tell me the calaculation for future use.
