Interested to Buy Any Domain ? << Click Here >> for more details...
tell me about the instrumentation,what is the actual need
of it ?what are the characteristics of a IC engineer ?
- 11 Answers
- 17002 Views
- L&T, I also Faced
- E-Mail Answers
Answer Posted / karim
Instrumentation is the branch of ingineering which deals
with measurement and control of all process variable.such as
pressure,temparature,level,flow,ph,conductivity etc.
to run any industry in safe and accurate with in limited
resources ,we must need this instruments.if the istruments
are not there,what happening in the process we don't know.
| Is This Answer Correct ? | 4 Yes | 0 No |
Post New Answer View All Answers
How d.p. Transmitter can be applied to close tank?
Q1]IF THE RANGE FOR FLOW IS -35 TO 125 WHAT WILL BE THE SPAN FOR ABSOLUTE AND FOR NORMAL? Q2]HOW TO CALIBRATE CAPILLARY TYPE LT? Q3]HOW MANY ERROR CALCULATIONS ARE THERE USED IN PROCESS INDUSTRIES? Q4]HOW TO CALIBRATE TEMPERATURE TRANSMITTER? Q5] HOW TO CALIBRATE LEVEL TROLL AND HOW TO CONNECT? Q6]PLEASE TELL ME THE BASIC FOR INSTRUMENTATION WHICH IS APPLIED FOR CALIBRATION AND FOR ALL? PLEASE MAIL THE ANSWER TO honest_yes@yahoo.in
What is the difference bitween control net scaner and device net scaner
Explain plc level and its type?
what is the protection system in solar turbine compressor
What is Cavitation in a control valve?
Conversions
What is motion balance principle?
Define cryogenic?
give some question relative instrument fitter?
How an rtd work, and what volts/current goes to a rtd to measure the resistance?
Is it ok, to use non-contact type Radar type LT, on a tank that is half circular from the bottom side? If yes the, isn't the waves gonna bent in other directions?
when the instrument tapping on pipe line is located below and transmitter is located above the tapping point for liquid service transmitter, what should we do, is there any additional drain valve is required??
how do we commission inergen system?
What are advantages and disadvantage of the ac supply load cell?
