In a generator (Synchronous) does the rotor speed
(frequency) corresponds to the speed of the water (in
hydro). does the torque on the turbine relate to the flow of
water?
- 2 Answers
- 3429 Views
- I also Faced
- E-Mail Answers
Answer Posted / milinda
when we increase the flow of water (m3/s) by the governor
(controlling the AREA of the water inlets) we change the
torque on the turbine not the speed,right? but can we change
the output frequency changing the SPEED of the water flow ?
| Is This Answer Correct ? | 0 Yes | 1 No |
Post New Answer View All Answers
area control error
Explain what is clipper and clamper circuits?
Advantages/Disadvantages of earthing of neutral bus on MSB instead of separate neutral earthing for transformer/DG sets feeding to MSB
What are locations arc protection relay is fixed.
why we used ZNO in Lightning arrester.
what is effect of length of air gap on performance of dc motor and generator?
Where servomechanism is used?
When we use air circuit breaker, it has O/L protection ,time delay SC protection, Instataneous SC protection & ground fault protection. They all have some setting range. But what is the suitable/allowable setting for the above protection which will be safe for the equipment? For example-O/L protection setting have a range of (0.4,0.45,0.5,0.55,0.6,0.65,0.7,0.8,0.9,1.0)xIn Time delay SC protection have a range of (1.25,1.5,2,3,4,6,8,10,12)xIn Time delay setting is 0.02,0.1,0.2,0.3,0.4 Instataneous setting is fixed to 20xIn Gound fault setting is given 100A,300A,600A,900A,1200A This setting are for 2500A ACB. So what will be the basic allowable setting for the above protection? is there any formulae to calculate this<
how you configure motorvision relay (L&T make)from DCS
WHAT DO YOU MEAN THE DIFFERENT TYPE OF CURVES OF RELAY LIKE STANDARD INVERSE, VARY INVERSE, NORMAL INVERSE, LONG INVERSE ETC....
please suggest some good universities with low cost iam in totally full confusion so please help me my profile gre 283 and ielts 5.5
which pump used in STP
3 shows a 415 V, 3-phase generator supplying a 3-phase 415/110 V transformer. Draw the individual and combined impedance diagrams to a base of 10 kVA. Determine the system fault kVA and the fault currents at the 415 V and 110 V busbars for short circuit faults on the transformer input or output terminals. Work in p.u. values of impedances.
State the points to be considered for selecting a particular type wiring.
How to calculate the heat load for a electrical room
