Interested to Buy Any Domain ? << Click Here >> for more details...
Answer Posted / arunachalam
High voltage is dangerous instead of high current
practically we say DANGER in Board like 11000v,23000V not a
current .
Always high current/low voltage used in welding machine but
welding rod not give a shock
| Is This Answer Correct ? | 4 Yes | 5 No |
Post New Answer View All Answers
If any one's require of phoenix contact like( relay , termilnal block , surge protection device ) , product please contect me 09878206357 chetan verma
draw the full wave and half wave circuit of 3 phase system and inverter circuit used in ups
design a 3 bit synchronous and asynchronous counter using T- flipflop
solor panels arrange some angle,panel is flat fitted energy was produced or not why?
Tell me about ur past electrical maintanence job
What is an automatic controller?
if the load is 80 amp for main fuse and 100 amp for breaker so how can we calculate the cable size (cooper ) .
Why do we perform an open-circuit test and short-circuit test on the transformer?
kindly send me 11KV MV motor differential protection procedure by primary injection method.
we have 3.5MVA-11/6KV transformer. how can we calculate earth fault current and NGR calculation?
is it possible to say motor horsepower number without seeing name plate(when name plate damaged)
Match the following a)(X'+Y') b)X'Y' C)XY 1)NAND 2)NOR 3)Carry
What is cut-off rate?
all interview questions with answers of ntpc (2000-2009
What is a commutator?
