In a generator (Synchronous) does the rotor speed
(frequency) corresponds to the speed of the water (in
hydro). does the torque on the turbine relate to the flow of
water?
- 2 Answers
- 3428 Views
- I also Faced
- E-Mail Answers
Answer Posted / lokeshraj
In generator the rotor speed thus frequency varies
according to the flow of water, speed increases with
increase in water flow, turbine torque depends upon the
flow of water....
| Is This Answer Correct ? | 2 Yes | 0 No |
Post New Answer View All Answers
In the ACB breaker capacity is 2000Amp but this each phase taken 1250 But total beldibg load is 600amp or 700amp watt is the problem
what are the protecyion of transformer & generators
how many parameters can integrate with fire alarm basically ?
Define cut-off rate?
High speed earth switch operation with diagram
what is the difference between RMS & TRUE RMS VOLTAGE
What is shunt voltage and u v voltage witch one best
wat is d diffr btw shunt coil and trip coil in VCB?
All tape of electrical questions Answers tape of motor transformer e.o.t crane
i am going to attaned the engineer (disign)iterview at HAL please give me duid line
how net resistance islow in star connection and viseversa in delta connection...? if anybody could explain in detail it wud be helpful.
An impedance of 100 ohms resistance and an unknown inductance is connected across the capacitor. The resulting impedance is a pure resistance of 500 ohms ifω = 10^5 rad/sec. calculate the values of inductor and capacitor.
Define gain margin?
What should be current in the Primary and secondary side of 1000KVA (11KV Supply)Transformer.?
how to select the automotive wire size by mathematical calculation. for xenon headlamp with ballast. the ballast given data voltage 10-17v,current permenant 6amp, run up phase is 15amp, peak at swicth on max 400micro sec is 40amp.the sum of cable resistance is 150mohm.please provide referenc document if any for relating the peak at switch on current,time & wire wire size
