Interested to Buy Any Domain ? << Click Here >> for more details...
What are the factors considered for the selection of cable?
- 6 Answers
- 35406 Views
- NPCIL, I also Faced
- E-Mail Answers
Answer Posted / sayan banerjee
1. current carring capacity based on its cross section.
2. insulation types(pvc,xlpe,trs)
3. no of cores
4. voltage level(HT / LT)
| Is This Answer Correct ? | 8 Yes | 2 No |
Post New Answer View All Answers
What will happen if the d.c. Machine is operated below rated speed?
My question is abt backlog.I had dropped one subject in my second year, and completed this subject in the 3rd attempt, so how many backlogs i have got?1 or 3?plz sujjest the answer as soon as possible
explain with diagram how to protect transformers and substations from over current with help of CT's?
can we use trip light with bus coupler?
can any one know is sbi interview based on merit or based on roll number
HI....HOW CAN BE MESARED THE VALVE OF NEUTRAL GROUND RESISTOR WHIC IS LOCATED AT SWICHGEAR ON GENERATOR SIDE....
in wind mill use 2100 kw asychronous generator ( induction generator ) rotor voltage : 3300,stator voltage : 690, rpm : 1511 type : MRL063E04 ' we check rotor resistance magger value found following. R-EARTH - 00 M.OHM,Y-EARTH-34 M.OHM,B-EARTH- 33M.OHM R-Y: 31 M.OHM, Y-B: 00 M.OHM,B-R :33 M.OHM HOW CAN I TAKE DECISION?pls ans. quickly
sourse is 66 KV / 350 MVA, transfarmer is 1000 KVA 6.6 / 0.415 kv, iF fault is 28.75 MVA on 0.415 KV Bus then calculat the Transfarmer Impidance
which type of effect of turbine and generator reverse power protection ?
Difference between Earthing Truck & Earthing trolly for HT panel
What is meant by Low Resistance Cable and High Resistance Cable.
what is meant by the phrase 'static load' in case of shorting in a generator excitation system?
How we calculat the NGR of 3phase Generator, Our generation voltage 11KV
technically, what is the reason behind starting the motor star the delta connection .. and what other ways to do this rather than using " star-delta transformer"
why do we measure VIBRATION in -24vdc and why we adjust gap voltage -9vdc to 10-vdc? i am trying to get this information since 5 years, yet i haven't get reliable answer, i hope i can get from you.
