Why any transmitter signal is 4-20 mA only
Why is started from lower range 4 mA and upper range is
20mA.
- 5 Answers
- 10883 Views
- Edac, I also Faced
- E-Mail Answers
Answer Posted / girish
this answer which are not exact answer
1. signal is linear
2.no noise
3.current signal will not drop
| Is This Answer Correct ? | 0 Yes | 3 No |
Post New Answer View All Answers
hello sir/madam, I,Subramanian need 5yrs placement papers of officer trainee of Instrumentation technology.pls send to this mail id mani_nxtgen@yahoo.co.in please do the needful. with regards, subramanian.v
please send the drdo exam paper
Why do you want to work here
how to calibrate and troubleshooting of leveltroll?
i hav applied for the post of engg. in iocl so please require the past test papers fro instrumentation engg please please help me and send me the papers or tell me the pattern and type of ques asked in examination......
Give an example where you had aproblem on the job, and tell me how you solved the problem. and the finalvoutcome.
What is force balance principle?
what is cems analyzer explain with principle and drawing ?
What is ultrasonic flowmeter?
Calculate the maximum pressure drop that can be allowed to occur across a control valve, so that we can prevent cavitation / flashing from occurring. Use the following formula: Δ P allow = Km (P1 – PvapourA) where, Δ P allow - the maximum allowable differential pressure for sizing purposes, or terminal pressure drop; Km- the valve recovery coefficient from the manufacturer’s catalogue; P1 - absolute inlet fluid pressure; PvapourA - absolute fluid vapour pressure at the inlet temperature; Use Atmospheric pressure = 101.3 kPa, P1 = 1200 kPa(g), PvapourA = 4 kPa, KM = 0.72
, Instrument Index, P&ID review, I/O schedule, datasheet, DCS / Analyzers specifications, loop diagrams, hook-up drawings.
What is shielding effect?
What are the error values can accepted in flow transmitter calibration?could u give any formula for this?
Explain an adaptive / self-tuning controller’s major draw card.
what is the procedure of O2 sensor(ABB) calibration?
