Interested to Buy Any Domain ? << Click Here >> for more details...
Answer Posted / sandeep
Transformer must not be connected to a DC Source because if
the primary winding is connected to DC Supply mains, the
flux produced will not vary but remain constant in magnitude
and therefore no EMF will be induced in secondary winding
except at the moment of switching ON. Also there will be NO
Back EMF induced in the primary winding. Therefore a heavy
current will be drawn from the supply which may result in
the burning of the winding.
In Transformer, If primary winding is connected to a source
of alternating voltage, an alternating flux is set up in the
laminated core and links with the secondary winding of the
transformer in which it produces mutually induced e.m.f
according to the principle Faraday's Laws of
Electromagnetic Induction.
| Is This Answer Correct ? | 10 Yes | 1 No |
Post New Answer View All Answers
What is Icu and Ics and what is difference b/w them. please tell me how to calculate a size of a copper bar for a system or a breaker... reply on... king.arish@gmail.com would be waiting for a logical answer.
What happen when neutral point connected to core balance current transformer? (Neutral point of an alternator of a 180KVA DG. Neutral point connected to CBCT means enter to the CBCT)
how flow current in 220 kv line to line
State thevenintheorem?
how we can find of current direction(supply comming/out going direction) when a transmission line passing through sides.
substation+ plc system
Where burned of electricity,when,who, & why.
The screw thread commonly used for transmission of motion is one of the following types of threads
During FEED, you will have all the information with regards to cable. How will you calculate the MTO for MV and LV Cables? what are your considerations?
How does HT work & Voltage required?
I use 20 nos led tube 4feet, in pathway 100mtr approximate, so what size cable i use for lighting
Which are resistive loads & which one are inductive loads : Refrigerator, Split air conditioner, ceiling fans, well pump, fluoresecent bulbs, T.V, CRT Monitors, Adsl Routers, C.P.U, Printers, Deep Freezers, Speakers, DVD Players, Microwave oven etc. ? Output Power for these Appliances Would be same like this : P = V * A * P.F Or would be changed ? thanks
I HAVE A INCOMING 100A MCCB TPN 25KA, CABLE LENGHT OF 80M 70MM CABLE SIZE FROM MAIN SUBBOARD TO NEW DB.BASE ON THE FAULT LEVEL SETTING OF 45KA.I WOULD LIKE TO FIND OUT 25KA ENOUGH KA. APPRECIATE IF SOMEBODY CAN ASSIST ME WITH FORMULA FOR THIS. FRM: JEFF
hello everybody. what does an abnormal stator winding impedance or dc resistance show? thanx
How are load losses and no-load losses measured at site in a DG set?
