If a fixed gear having 200 teeth is in mesh with another
gear having 50 teeth.The two gear are connected by an
arm.What will be the number of turn made by the smaller gear
for one revolution of arm about the center of bigger gear?
Any effort is appreciable witha proper logic..
- 8 Answers
- 14063 Views
- I also Faced
- E-Mail Answers
Answer Posted / vijay
4 revolution made by the small gear for one revolution of
fixed gear
200/50 = 4
| Is This Answer Correct ? | 1 Yes | 5 No |
Post New Answer View All Answers
what are the parameters are selected while manufacturing a single cylinder block?what are the different kind of test is conducted on it so that it can withstand with all those condition which required to run the engine efficiently.which force is act when piston slide inside the cylinder.
After any cause of repaired how i start the engine by slow speed 800 to 900 rpm electronic control moudle engine [cummins]
explain the mixture requirement of si engine to meet the demands of various operating condition?
why are using ahu?
Why PWHT IS NOT DONE TO STAINLESS STEEL MATERIAL?
If anybody have the ref. design book of the 3 point cylindrical rolling with sheet thickness of 2.3 mm & 67 mm internal diameter legth of 80 mm
write 2 important assumption on fin theory?
What is the effect of inter cooling in gas turbines ?
How to stoped water tube boiler
what is EN in pipes property?
What is the purpose of air cooler of D/E?
Explain the rule to find specific heat of aqueous solutions.
why we transfer FA(full arc) to PA(partial arc) in steam turbine at specified load?
How much of MSW waste is to feed to produce 1MW ?
Explain the advantages of cycloidal and involute gears?
