Interested to Buy Any Domain ? << Click Here >> for more details...
Answer Posted / deadzg_devil
Y-D starter is used in starting of IM.
The main purpose of using this topology is to reduce the starting current of IM.
As in Y the voltage will be 1/root 3 time line voltage therefore current drawn will be less as compared to in D connection.
When the IM motor attain 75% of it's rated speed at this the connection is changed to D topology to attain full speed.
| Is This Answer Correct ? | 12 Yes | 1 No |
Post New Answer View All Answers
71ohm,111ohm,95ohm,179ohm in calculate the total ohm in series circuit
Zone of protection and tripping scheme of arc protection relay.
how to calculate the power factor when instantaneous voltage and current has harmonics in it ?
is that a problem if i connect a single phase load to a secondry delta connected transformer but i get a neutral from other transformer i the system?
bitumar
IF HT CAPACITOR IN ON POSITION IS THERE ANY LOSSES I.S I SQURE OCCURS IN THE SYSTEM
What is MS-EXCELL?
If I want to lift the water at a height 50m from ground level through two inch(diameter) metal pipe then what is the capacity of motor pump is required? is it possible in single phase supply or not?
what is the function of statics switch in ups and tell me parts
Y phase plates are used in transmission line??? what is there need???
difference between crane drive and line drive.
What is the disadvantage in proportional controller?
difference between main metering kiosk and check metering kiosk
what is value of Jin transformer
why we use the 100% and 95% stator earth fault protection for the synchronus generator ?
