what is transformer
Answer Posted / rahul singh
transformer is a stationary device, which transfers electric
power from one circuit to another without change in frequency.
| Is This Answer Correct ? | 0 Yes | 1 No |
Post New Answer View All Answers
What types of CMOS memories have you designed? What were their size? Speed? Configuration Process technology?
Cables Construction hi friends, 0.6/1/1.2 kV LV , DC and Control cables are concentric copper conductor what does its means and what is the use of concentric copper conductor,and are this with copper tape shield or copper screening, ? thanks
what is the function of anti pumping relays? what is KVAR? How it is generated in alternator? What is 3rd Harmonics? What is IDMT relay?
Hi guys! Plz help me to answer the following questions. 1. What are the types of transmission line energy losses? 2. Why are the VLF are used some types of services? 3. What frequencies are used for reliable beyond the horizon terrestrial communication without repeaters? 4. To permit selection of 1 out 16 equi-probable, what is the number of bitis required? 5. What is the most common modulation used for telegraphy? 6. What is the multiplexing is used to increase the capacity of the optic fiber? Thanks
What do you mean by a voltage transformer?
what is the difference between gas group b and gas group c electrical equipment construction wise?
In a carnot engine with an efficiency of 40%, the heat rejected to the sink at 27 C is 60 kJ, then the heat supplied in kJ to the engine by the sources is
What is superposition theorem?
To make a basic instrumentation amplifier, it takes A One op-amp with a certain feedback arrangement B Two op-amp and seven resistors C Three op-amps and seven capacitors D Three op-amps and seven resistors
we have a lot of model of rectifier but thyristor rectifier is the most rectifier that use in power system. Do you know why this rectifier is used?
WHAT WOULD BE THE FORMULA OF WIRE GAUGE FOR A FULL LOAD CURRENT
HOW TO CALCULATE AMPs OF CURRENT TRANSFORMER IN HT Panel
Is it possible to use a S1 duty class motor for crane application (S4)? If not, why?
What types of question are done for diploma students in aptitude test
What is meant by system?