Answer Posted / ujjval solanki

20 means 20 mPa and 30 not clear but may be temperature at
which concrete should carried out

sir i want to know that in L & T construction can we do our 6 months training proggramme cum placement???????

2313

---

suppose we have a tendency to make a hole on the surface of the simple supported beam, than where we goes to make it?

2108

---

how to calculate the length diamond shaped striupps in column

2829

---

In Abutment walls (A1 side) why we are adopting fixed bearing (POT-PTFE)?

2142

---

how to take the quantity of block work and plastering  1block price:3saudi riyal cement:1bag:15 saudi riyal sand:3bag:20 saudi riyal 1mason:9hour per hour 40 saudi riyal 1labour:9hour per hour 40 saudi riyal can anybdy calculate

2520

---

how to nfind out the specific gravity of sand.aggregate,water please help...

2269

---

How musch steel i.e. angles, channels,and square pipes are required per square feet for a steel roof of residential two storied building?

1843

---

Why the finite element method is lower bound solution?

3051

---

how do you calaculate the total steel quantity of an rcc building using thumb rule?

3753

---

Which is the indian standard code of line out. ? How much tolerance fot 1 mt lenght? Its challenge....

2439

---

difference between trapezoidal and pedestal footing and how the load acts on that

2971

---

what is the water cement ratio for plastering

1690

---

while doing the structural works of a simple ground+1 villa, can the columns be continued immediately after neck columns without tie beam, while the tie beam to be done after columns concreting.

1696

---

What is the veriplus for ellips card length formula (major axis 3.4m,minar axis 2.6m spacing 0.2m

2246

---

I want to know the relevant IS codes of practice which deals with different testings of cement-sand mortar (nominal mix)that is being normally used for brick work or plaster work in the construction work.

2129

---