Interested to Buy Any Domain ? << Click Here >> for more details...
What Normal(Tangent) towers and Tension(Cut-point) Towers?
- 1 Answers
- 6288 Views
- ABB, BGR Energy, NTPC, Powermec, I also Faced
- E-Mail Answers
Answer Posted / mohamed
If the whole transmission line is normal towers and one
tower is broken,all towers will fall like domino one after
another because this tower cannot withstand tesion to the
sides it only can hold the weight of the conductor that is
pulling it downwards and the left and right tension will
cancel each other. So we use tension towers between every
4 or 5 normal towers, so when one tower is broken the
broken tower will be bounded between 2 tension towers,
these 2 towers will isolate the the tension because they
can withstand the tension to right or left.
| Is This Answer Correct ? | 4 Yes | 0 No |
Post New Answer View All Answers
SUTIABLE FOR ohm's law super conductor
im working in one private compeny in gujarat. i was complet diploma electric in 2010 from gujarat technical board. now i want electric supervisor licence in gujarat but i dont't know when i apply? plz give me address of the licence dippartment office in gujarat. gandhinagar
how ct burden,magnetising current,ratio and knee point voltage are related & derived
WHAT IS THE WINDING PROCEDURE OF ELECTRICAL MOTOR
i have a 4 Mva transformer 34.5 kv / 480-277 v and i used 2 parallel 3200 amp bus duct for the secondary feeder using 3 ply of bus bar ( 3/8" x 5" ) as a common where the flexible link terminated and 6300 amps breaker for the main, the lower bus duct reaches 70 degrees and the upper bus duct reaches 55 degrees when i used thermal scanner. why the temperature is not balance when the load reaches 3600 amps.
Why DG set is not installed in Terrace ??
Mention the disadvantages of low power factor? How can it be improved?
if we apply 1000ADC instead of 100ADC or We apply 50ADC instead of 100ADC,What will be happened in the test result value.Pl explain
How to select a cable size for particular load?
how could we calculate the no of outgoings from a 800 watt distribution board
what are the interview question asked in wind mill about electrical
if two transformers are placed parallel & both have fault impedance of 50KA will it increase or decrease show example?
List advantges of active filter over passive filter?
How many methods use the load flow solution?
What is the formula to calculate the rating of power cable for three phase current.
