Interested to Buy Any Domain ? << Click Here >> for more details...
what will happen when reverse reactive power occurs in
alternators?
- 3 Answers
- 21840 Views
- Reliance, I also Faced
- E-Mail Answers
Answer Posted / shrishail h b
When alternator reactive power goes to negative, running
with Grid. Also alternator power factor it goes to leading.
It condition alternator will draw the reactive power from
the grid. So, we ajust the alternator reactive power always
positive side, means running MW load around 30% MVAR.
| Is This Answer Correct ? | 9 Yes | 3 No |
Post New Answer View All Answers
is this the formula of building wiring to get the main breaker.Watts/volts*.8%+higher motor*(25%)=ampere. yes or no or send the correct formula for building wiring.
What is the use of oil in transformers?
Hello Friends, How can we recognize the CT Star Point is S1 or S2 in case of Electro Mechanical Relays and what is meant by Restraining coil in relays and what is the purpose of that.. thank you in advance..
Which test will be more severe for VCB?
How we can determine short circuiting current any plant and for example a plant which power generation is 415 volts and plant load is 500 kw.
what is the acceptable limit value for Desolve Gas Analysis/
what is the need to express current and voltage in rms value? rms value is also called as effective value,what is effective value?
why we not used 11kva as a direct our electrnics component.
A 100KVA SINGLE PHASE TRANSFORMER 10000/200V,50HZ REQUIRES 300V AT HV SIDE TO CIRCULATE FULL LOAD CURRENT WITH LV SHORT CIRCUITED.THE INTAKE IS 1000W.THE % OF REGULATION ON FULL LOAD AT 0.8 PF LAGGING WILL BE HOW MUCH AND THE SECONDARY TERMINAL VOLTAGE ON 0.8 PF LEADING WILL BE
WHAT SHOULD BE THE BEST CURRENT RATINGS (PRIMARY / SECONDARY)FOR A CT INSTALLED AT THE INCOMING 11KV PANE? WILL IT BE CALCULATED ON THE BASES OF MAXIMUM DEMANT VALUE OR ON SUM OF ALL TRANSFORMER'S KVA? NOMALLY MAX DEMAND REPRESENT THE MAXIMUM OPERATING LOAD OF THE PLANT AND TOTAL KVA OF (SAY 5 NUMBERS TRANSFORMERS) REPRESENT THE CONNECTED LOAD. WHICH i.e. MAX DEMAND KVA OR CONNECTED KVA ARE BETTER TO USE FOR CT CURRENT CALCULATION? PLEASE ANSWER.
why wire sizes are 3/29 or 7/29 and why not wire sizes are 2/29 or 6/29?
what is meant by neutral compensation factor and where it is used
List the time domain specifications.
How to test Alternator stability test for REF relay
The 3 phase Delta connection RB=440V, BY=350V,.......* is Line to Line voltage RY= ? And Formula....?
