Interested to Buy Any Domain ? << Click Here >> for more details...
why we use stones or rock pieces in transformer area?
- 10 Answers
- 31195 Views
- I also Faced
- E-Mail Answers
Answer Posted / pratik
The main reason is that of stepping potential. In the transformer area stepping potential should not be more than a certain value. We know the fact clearly that we cannot walk fast over stones, our steps do become slow, and with this our stepping potential becomes less which is required for our safety.
| Is This Answer Correct ? | 5 Yes | 4 No |
Post New Answer View All Answers
What is meant by stator?
How PSV sizing being done
5- What is the task (function) of the excitation and isolation transformers in power plant? 6- What is the task (function) of LCI (A), LCI (B) and LCI (COS) in power plant? : LCI (A) and LCI(B) are load commutating inverter for generator turbine starting. , LCI (COS) is load commutating inverter change over switch
what is the reqirred voltage in HT motor to get full RPM on no load test?
why asa method ZPF method is more accurate than ASA method?
Why the dc voltage drop during starting of emergency lube oil pump? The Voltage drop from 135kv to 125 kv for one min. before re-establish to 135kv?
How to calculate cable size by using load.?? Any formula...
what is the safety of voltage power transformer(2250KVA0
State and define norton’s theorem?
why the difference arise between HT reading & LT reading (submeters fixed in complexes, apartments etc)if the power factos exceed from 0.9 to 1 can the ht meter reads fast?
what is the transiant condition in alternator? and how it can be prevanted?
how are reversing the direction of rotation of dc motor
As an electrical engineer what are the responsibilities which i can hold in TCS?
Good morning: I'm looking for some informations about the OLTC or the LTC: I wont to know what the function of the tie-resistor in during the operation of reversing/coarse operation Cordially
what are the different methods for the starting of a synchronous motor.
