Answer Posted / edward411

that's the minimum loop resistance needed to communicate
via hart protocol u exeed the value it will still work

Calibration procedure for water rotameters

2188

---

What is difference between “Fault Tolerant” & “Fault avoidance” PLC? Application where these system s are used?

3924

---

applications of plc in printing and packaging?

2192

---

Valve positioner and actuators in detail.

1783

---

what is performance test.need defination

1702

---

Dear Friends, we are planning to design Power distribution and Fiber optic in the same cabinet.Like Front side Fiber optic and Rear side Power distribution.Is it any possibility of problem occurs like interference etc? Your answer is highly appreciate.

2210

---

Why 4-20 amps is being used in instruments? Why cant we use any other range instead of 4-20 amps? Why only 4 amps is taken as lower limit and why 20 amps is taken as the higher limit?

1515

---

Sir, I want junior executive, Instrumentation question papaer for IOCL, Plz send to arabinda.ghosh83@gmail.com

2295

---

Why we are using reverse action in displacer types level transmitters on some Vessels?

2530

---

Actual using of tube bender to bend 2 opposite 90 deg at correct measurement center to center of tubing.

1886

---

Derive capacitance to 4-20ma conversion formula / relation in capacitance type pressure sensor?

2232

---

what is a half wave, full wave, and bridge rectifer.

1774

---

key exchanges in wpa,wpa2,tls

1915

---

How to control flow variations in magnetic flow maters..... When i will provide proper earthing?

2312

---

hi my name is rakesh patel i just complited my be in instrumentation & control now i am going to working as a validation engineer in a poject department so what is a scope in a future as a validation engginer ? what line is good for me can any bady give me complete solution please? your regard rakesh patel

1961

---