In a transformer, the hysteresis and eddy current losses
depend upon
1.load current
2.maximum flux density in core
3.type of lamination
4.supply frequency
The correct statements are
(a) 1 and 3 (b) 2 and 3
(c) 1 and 4 (d) 2 and 4
- 9 Answers
- 10915 Views
- I also Faced
- E-Mail Answers
Answer Posted / kuldeep
hysterisis loss=f*b^1.6
eddy losses=f^2b^2t^2
so it means these losses corresponds to frequencyand
maximum flux density
| Is This Answer Correct ? | 2 Yes | 0 No |
Post New Answer View All Answers
In a tap changing transformer where is the tap connected, is it connected in the primary side or secondary side?
Can we use both Electrical & mechanical interlock between tow breakers? if yes how, please explain
Give me the calculation steps to design an electromagnet to be work in 230V 50 Hz AC Supply. Also give force that is created by that electromagnet when it gets energized.
explain PV modules in solar energy generation.
what is the advantages of having in-built acvvvf (without seperate inverter in the control panel)in the drive system of elevators?
does a DG set has low fault level as compared to that of a transformer.If yes then why.
How to arrange a hous hold earthing system to keep minimum earth resistance( below 7ohms).
HOW TO SELECT THE COPPER CABLE SIZES OF MOTORS,TRANSFORMERS?
what is the difference b/w ATS and HTS?
How can I known multiplying factor .without multiplying table
what is basic difference betmeen normal & flame proof motor??
What is the tension required for the 25000 CFM AHU belt
What is the de rating factor of cable? What is the importance of the de rating factor in cable select
How equivalent impedance is calculated in thevenin theorem?
what is the minimum requirement gigaohms for the insulation test using 5kv in 300mm xlpe cable
