why threre are two parallel lines in transformer's symbol?
- 11 Answers
- 28404 Views
- NTPC, I also Faced
- E-Mail Answers
Answer Posted / kuldeep
it shows mutual induction between two coils
| Is This Answer Correct ? | 1 Yes | 9 No |
Post New Answer View All Answers
Hi I'm doing my MBA(3rd semester).I applied for the post of ET conducted by BHEL the last year.I cleared the written and lost in personal interview.Again I wrote the exam this time and cleared the written n yet to take the personal interview.Shall I disclose in the interview about my studies.What shall i say if they ask about my change from studies to job
What will be the fault current of any system when its generation is 10% of BASE generation( FUll Load )?Will is 10% or the same as full base calculation?
i am an maintenance engineer. one distribution board have 5 feeder. recently its ELR trips frequently, but it take some times after trip( 10min,20min..)but 3 feeder no load. two feeder only loaded. i checked one feeder IR value all values are above 50Mohm.but B phase to Earth is only 9Mohm.any problem about low value
How is the speed of a DC shunt motor related to the armature current?
how to avoid electrical shock how capacitor store charges wat are the speed control of induction motors state faradays law flemings left hand rule what is rotary converter wat is transmission and distribution what are the sources of energy abrevation of acb,vcb,sf6,igbt what is output equation of transformer which test copper iron and iron loss are calculated what is eddy current draw a single line diagram (10 marks) draw direct online starter(10 marks)
How Can I calculate for the photometrics requirements for a street lighting? Data given are: 45 units of 6 meter light pole with 150 watts metal halide lamp, 220 volts and installed in a promenade area.
Witch do depand of Power factor and theory of power factor?
What is bridge rectifier and explain with details
how does high earth to neutral voltage affects electronic circuit?
why do we not use equivalent voltage source in negative sequence equivalent ckt.
Pl. give me checklist for installation & commissioning of machine tool.
what is the difference between Power and Distribution transformers ?
What is core CT & it's function?
why occ characteristics curve in not tracing back when we are bringing back the rhoestat?
Which motor connection is preferable star-delta or delta-star?
