Interested to Buy Any Domain ? << Click Here >> for more details...
what happen if position of GNA and MNA is changed in
machine?
- 3 Answers
- 9320 Views
- I also Faced
- E-Mail Answers
Answer Posted / abhidewas
ideally both MNA GNA should coincide. if they are interchanged then sparking at the brushes may happen. also because of armature reaction terminal voltage may decreased.
| Is This Answer Correct ? | 8 Yes | 0 No |
Post New Answer View All Answers
why we change the direction of winding in rotor ?how we make the north and south pole?
how we can adjust for three phase motor cold stall time ,hot stall time and thermal register set up?
Will any motor burn if voltage provided is lesser than the rated voltage???? If yes, then how is speed control possible with voltage control
No load tap changing transformer working
How many energy meters can be connected on a 15VA Voltage transformer. please send a calculation sheet.
How to do fabrication , busbar and wiring cost for : 1. LT Panels 2. C& R Panel
which cable is used for 15 Hp monoblock pump 3phase and service wire Distance is 210 feet please tell me cable size Armaured
How is efficiency of DG set calculated? At many places I found the efficiency to be mentioned in percentage. But at some other places I found kWH/ litres. I want to know how dimensionless percentage value is arrived at?
what is the id1 & id2 setting in differential protection relay of CSPC?
Write the current equation in series RLC circuits.
if the load is 80 amp for main fuse and 100 amp for breaker so how can we calculate the cable size (cooper ) .
what are the precuation should be taken ahen installing power transformer,circuit breaker,current & potential transformer
when qty of cable being purchased is not sufficient according to the standard,what should the inspector do to ensure its quality according to the standard?
Can anyone tell the proper diagram of star delta starter????
please send me last 5 year interview questions
