why two wires are wound alternately to each other in single
phase wires?
Answer Posted / apoorv
this is transposition to reduce the
interference of power lines with
nearby communcation lines.
Is This Answer Correct ? | 2 Yes | 0 No |
Post New Answer View All Answers
how is positive, negative, zero sequence is happen.. how is effect on 3 phase system
How we calculat the NGR of 3phase Generator, Our generation voltage 11KV
I AM GOING TO ATTEND APTRANSCO ON 26TH OCT 08.PLEASE SEND ME ANY MATERIAL OR TYPE OF QUESTIONS OR EXP QUESTIONS.
What type of DC motor would you see for a lift?
i want to know about torque of slip ring induction motor
I want to calculate how much capacitor we connect to maintain the unity power factor? Is there any formula? Pls give me the answer
if grounding is notdone at regular intervals for long distance transmission, will the load connected at distribution end receive voltage during negativehalf cycle of the sine wave?
which type of motor is used in automatic swing gate
How to Prepare preventive maintenance shedule of machine tool.
what is th basic difference between a d latch time line and a d flip flop time line???
in a simple IDMT relay we use neutral point of ct for earth fault then what is the requirement of neutral ct and cbct?
What is the theoretical reason for the size of a zig zag grounding transformer to be 1.732 times less than that of a wye-delta grounding transformer used for the same application?
I have made a 3 phase thyristor full bridge rectifier. But at the moment it is working only for the half bridge operation. Both the half bridges are on operation separately but when i put it into full bridge operation the oscilloscope output is zero. I rechecked that the pulses are correct for each thyristor. what could be the possible reason for this?
how many parameters can integrate with fire alarm basically ?
why chock were used in old tubelights but are not newest tubelights?