Answer Posted / sreenesh shashidharan
In high-power gyrotrons it is desirable to combine an
optimal resonator length with the optimal value of the
resonator quality factor. In resonators with the constant
radius of the central part, the possibilities of this
combination are limited because the quality factor of the
resonator sharply increases with its length. Therefore the
attempts to increase the length for maximizing the
efficiency leads to such increase in the quality factor
which makes the optimal current too small. Resonators with
slightly uptapered profiles offer more flexibility in this
regard. In such resonators, one can separate optimization
of the interaction length from optimization of the quality
factor because the quality factor determined by diffractive
losses can be reduced by increasing the angle of
uptapering. In the present paper, these issues are analyzed
by studying as a typical high-power 17 GHz gyrotron which
is currently under development in Europe for ITER
(http://en.wikipedia.org/wiki/ITER). The effect of a slight
uptapering of the resonator wall on the efficiency
enhancement and the purity of the radiation spectrum in the
process of the gyrotron start-up and power modulation are
studied. Results show that optimal modification of the
shape of a slightly uptapered resonator may result in
increasing the gyrotron power from 1052 to 1360 kW
| Is This Answer Correct ? | 0 Yes | 0 No |
Post New Answer View All Answers
What are the differences between microprocessor and micro controller?
Explain the construction and pros of using plasma screens.
why the circuit turn off time should be greater than thyristor turn off time?
plz send jto previous papers
In order to handle all combinations of input voltage polarities, a multiplier must have A Four-quadrant capability B Three- quadrant capability C Four inputs D Dual-supply voltages
how can i do offset compensation , phase compensation and gain ratio using DAC?
i am kvsivanarayanareddy . i work in mnc company in engineering job. i completed B.Tech in electronics &communication , i want to prepare group 2 exams in ap. pls give me suggetion for preparing group, how iwill start preparation pls send to my mail .which topocis i will concertrate . how i will reach my goal pls suggest to my question.
what is the diffrence between S7 200 & S7 300 plc
Are you familiar in Basic console / mixer programming of DBX system
What are the uses of flip flop?
Tell me why do we convert frequency domain to laplace domain?
how we can calculate the range selection time in mobile communication? or channel searching time?
I am in need of question set of ONGC Electronics & Communication
Differentiate between transducer and transponder.
box1-a box2--a box3-a-1 in 3steps using any operation get a*(a-1)-(a-1)*a in box2
