why ground clearance of EHV line is more than HV line??
Answer Posted / k.prakashchandra
Higher the voltage more the ground clearance ,to keep the
touch voltage within limits.
| Is This Answer Correct ? | 2 Yes | 2 No |
Post New Answer View All Answers
How much should be the load percentage for 15kva Inverter and Iinut & I output load with Calculations
IF I KNOW THE AREA OF CROSS SECTION OFTHE WIRE , WATTAGE OF THE LOAD ,VOLTAGE SUPPLY WHAT IM GIVING TO THE LOAD AND ALSO POWER FACTOR OF LOAD ....... SO GIVE ME FOR WHAT AMOUNT OF CURRENT I SHOULD USE WHICH TYPE OF CABLE?
Suppose a 3 phase, 2 pole, 440V induction motor is driving a flywheel of 600mm diameter, 150kg mass. By using v-belt and pulley, the speed is increased to 4500 RPM. What will be the effect on motor current?
in HT service 3ph 4 wire service Y-phase voltage shows zero . whether it is meter fault? or what be the reason ? if y-ph voltage zero ,can current is recorded? reasons for failure?
Give the topology of current amplifier with current shunt feedback?
at work we have a 3 phase motor but on testing one phase isnt getting a reading. it runs 24 hours a day all week. stops and starts well no noise or heating. the phase isnt down to earth.is it just a bad meter reading or not? phases one and three came up with a resistance reading of 0.4 but phase 2 couldnt get anything shows up as open circuit.
what is fault level of power system ?
what is capacitor voltage transformer?? how it is different from potential transformer?
draw the full wave and half wave circuit of 3 phase system and inverter circuit used in upsĀ
Why it is possible to use PWM with a STATCOM and not with a conventional TCR based SVC
How to do stting of vl250 siemens MCCB
show the single line diagram of star delta starter with single phase preventer
How to Calculate the Fault Level of Electrical Installation
how can calculate resistance box for 15 kw, 6 pole, RV-230, RA-42 motor
description about dry type transformers