Interested to Buy Any Domain ? << Click Here >> for more details...
Is there any local or International standards that prohibit
the installation of earthing pit in the planters area where
the earthing pit is subject to continues soak in water?
- 1 Answers
- 3573 Views
- I also Faced
- E-Mail Answers
Answer Posted / k.prakashchandra
If earth pit is always wet ,the ER remains good always. If
corrosion is the problem ,cast iron pipe or superior quality
of GI pipe can be used.Planters are not exempted from
electric shocks.
| Is This Answer Correct ? | 0 Yes | 0 No |
Post New Answer View All Answers
WHAT IS START TO INDUCTION MOTER IN STAR TO DELTA OF >5HP ?
what is doubling factor in making current of a breaker?
To prove the capacity of a 10MVA transforemr with 6.5% impedance by a short circuit test how much power is needed to inject an impedance voltage if we have to arrive for its rated current?
what are the protecyion of transformer & generators
State the types of distortions in amplifier?
we have provided 30 nos. relay contacts in panel.I want to know how do we do the numbering for the relay contacts as per any applicable standards
which are the criterias needed to select the kind of neutral earthing(solid earthing,resistance earthing,etc.) at various voltage levels in electrical distribution?
How to calculate the phase to phase clearness of HT /// LT bus bar?????
WHAT IS THE CURRENT CARRYING CAPACITY OF 2.5/3 CORE HI TUFF CABLE,WILL IT SAFLEY CARRY 8.6 AMPS OVER 120 METRES,CAN YOU ALSO ANSWER WITH FORMULA FOR WORKINGS OUT ,THANK YOU 3RDYR APPRENTICE.
Hi, My plant daily consumption is calculated as 3.8MWH but my supplier has sanctioned an power of 2.6MW per day. how can i equal or distinguish this two factors
how we can come to know that motor winding resistance which showing by DMM is right or wrong???is there any chart or something that we will compare & check???
how we decide the require size is this for a known current at fuu load?
why would amp draw on neutral wire be as much as amp draw on the hot leg.
What is the alternate solution for testing of polarity by using polarity tester while its milli ammeter does not works?
I need a formula to calculate the size of cable as per load but in the terms of length. Please Reply me as i search lot of sites but i did not get the answer.
