While performing load test on DC SERIES MOTOR, does the
voltage decrease slightly. Why?
Answer Posted / abdullah
I want result snd concluation about Lod test On DC Motor By
using Vltmeter and Ammeter,Tachometer,Rheostats
Is This Answer Correct ? | 1 Yes | 0 No |
Post New Answer View All Answers
How line capacitance & line inductance varies with increase in height tower.
What are factors to be considered while we selecting the Core Balance Current Transformer for Earth fault protection
is there any chart showing the suitable cable size according to AMP and length ? for three phase motors
In Power Line Communication (PLC) the wave trap is used to block communication signals from entering neighboring lines. My question is this: Why do they allow for different filtering arrangements on these wave traps? Isn't it always going to be a low pass filter since we want the power frequency to go through, and the comm signal blocked?
What is resistance reading of earth copper rod with grid and without grid?
what is the chiller and working principal
What will happen to the protection and metering, if the polarity of a single or two PT/PTs in three phase system is reversed? Please provide reference if any.
What is pole of the system?
If the line voltage is reduced to 75% of its rated value then by what percentage current will reduce ?? 75% 25% 50% no change and why ?
Which device is used for the source of emission of electrons in a crt?
What are safety device in vcb and acb?
What is stepper motor. What is its uses?
why sometime we get electrical shock while touching the ballon of dish tv connection ? which we should not get.
can u tell me the promotion from oiller to enginer
sourse is 66 KV / 350 MVA, transfarmer is 1000 KVA 6.6 / 0.415 kv, iF fault is 28.75 MVA on 0.415 KV Bus then calculat the Transfarmer Impidance