Answer Posted / amar
rtd based on the positive temperature coefficient(resistance
increase as increase in temperature), metal used in rtd are
platinum, copper nickel etc
| Is This Answer Correct ? | 4 Yes | 1 No |
Post New Answer View All Answers
Programmable Logic control.
Describe how to use megger to measure the earth resistance and insulation resistance
For what reason would you possibly be compelled to make use of a Smith Predictor. Explain the idea behind the operation of this device.
the whole paper was based on Transducers..questions like define repeatability, error,accuracy,precision..den there were many q. on the conversion of Pa to mmHg and other units.. also..der wer few Q. on some level sensors(with diagram)
can you provide me full detail about instrumentation in ONGC??
I have a Control VAlve having size of 2 ".Only the known parameter is Pressure drop . Its 2 Kg. Then How to calculate control valve sizing means Cv.
What is standard procedure of manual mapping in Radar type level transmitter?
Explain why plc require in analog input 4-20amp & 0-10 volt?
i want formula for flow control.am doing project in flow control using orifice . i know value of the flow level(Q) . upstream(p1) pressure, orifice diameter(Do) , pipe diameter(Di) and oil viscosity(Vi) how can i calculate downstream pressure
What is the difference between ff transmitter and non ff transmitter
what is difference between fork type and capacitance type level switch. where it is using
Calculate the maximum pressure drop that can be allowed to occur across a control valve, so that we can prevent cavitation / flashing from occurring. Use the following formula: Δ P allow = Km (P1 – PvapourA) where, Δ P allow - the maximum allowable differential pressure for sizing purposes, or terminal pressure drop; Km- the valve recovery coefficient from the manufacturer’s catalogue; P1 - absolute inlet fluid pressure; PvapourA - absolute fluid vapour pressure at the inlet temperature; Use Atmospheric pressure = 101.3 kPa, P1 = 1200 kPa(g), PvapourA = 4 kPa, KM = 0.72
What is difference between radial vibration and axial vibration explain in detail .
Why do you want to work here
How you calibrate absolute pressure with the calibration range of 0 to 1000 0C Absolute. Please explain the procedure for calibration.
