What is the causes Power Factor become leading and what is the
effect of Electrical system ?
- 2 Answers
- 3651 Views
- I also Faced
- E-Mail Answers
Answer Posted / arnab singh
power factor is leading due to high capacitive load (more
capacitors used than required).
this causes unwanted heating in the system and increase
losses
| Is This Answer Correct ? | 10 Yes | 2 No |
Post New Answer View All Answers
I have one ct of ratio 3000-2000/1 Amp its knee point voltage mentioned on name plate is 500-333/30mA-50mA at Vk/2. in secondary box there is three terminal named 1S1, 1S2, 1S3 then on which terminal obtained the knee point voltage ie 1S1-1S2 OR 1S1-1S3 & also specify the knee point voltage for the ratio 3000 from name plate.
As per the Anchor capstan motor specification, full load current is 200A. starting current is 1750 A and acceleration time is less than 8 seconds. Please guide for selection of cable size.
what is difference between elr and R eartl realy.
How can we decide cable size from HT panel to Transformer? Please give you reply with some examples.
if a 3phase 100kva distribution transformer , 400 v,50 hz, 4-wire system is loaded at 160 k.w mostly 1-phase Lighting & Airconditioning split a.c load what will be the net effect on the power system in terms of voltage, powerfactor, current , efficiency of xformer
what is meant by moulded case circuit breaker ?
Thermal withstand capability under full short circuit conditions, in terms of number of times of occurrence of short circuit and corresponding anticipated percentage reduction in transformer life.
what is PDU in transformer?? which company manufacture??
hai iam arunkumar. i have applied for an section enginner in rrb. i want lat 5 years solved question papers. if u have please sedn it to arun30682@gmail.com
What is the formula to calculate the rating of a three phase air circuit breaker
What do you mean by transformation ratio of instrument transformer?
various transmission tower like .,D tower ,K.C.O tower ,C.C.O tower,K.C.R tower ,C.C.R tower ,H.C.O tower in different tons.
Why in 6 KV XLPE cable termination kit used and why not in 380 V xlpe cable same is not used
we have 2.2kw,Y,3000rpm motor but 6leads found in TB what happen if we connect in delta?
what is the use of surge suppresser in 33 KV incoming panel. where it must be installed,inseries with incoming cable surge suppresser must be at incoming of the breaker are outgoing of the breaker
