Answer Posted / anandh
First of all,electrical spark will happen and the power supply will be interrupted due to short circuit.....
Is This Answer Correct ? | 2 Yes | 0 No |
Post New Answer View All Answers
I have made a 3 phase thyristor full bridge rectifier. But at the moment it is working only for the half bridge operation. Both the half bridges are on operation separately but when i put it into full bridge operation the oscilloscope output is zero. I rechecked that the pulses are correct for each thyristor. what could be the possible reason for this?
How to Calculate Transformer Earthing Electrode Rod Size both Body and neutral Earthing ? Any Standard Formula? Please Suggted
what is the Pickup/drop off ratio in BCPU relays
All tape of electrical questions Answers tape of motor transformer e.o.t crane
What is given by the definition in BIL IMP/PF = 950/395 kV. This was found in a name plate of a power transformer.
In a Impedance Based Distance Relay (Quad Characteristics) - Could there be two different Line Angle(RCA) for Ph-Ph & Ph-Gnd? If So Kindly Let me Know.. Where, What are the advantages of the same?
UG cable sizes were specified in sqmm. But practically its not coming to mesure. What's the reason for that? And how they specify the size of the cable?
In india, according to trade theory above 5 HP motor reqired star delta starter. But we R connect 11 KV motor with 14MW in Direct to line ( With VCB starter combination) Can U Guess, How it is possible ?????
How to know about the rating(voltage and other) of induction motor if its name plate is missing at the manufacturing site.
salam,hi, i need to know what the spesification of 300amp msb...
Write the programming software name for LG, SIEMENS,Messung,AB
can i use the six sigma method which is used in management area, in state estimation of power systems?
does any one know where we can purchase insulation oil for high voltage oil filled cables
I HAVE A INCOMING 100A MCCB TPN 25KA, CABLE LENGHT OF 80M 70MM CABLE SIZE FROM MAIN SUBBOARD TO NEW DB.BASE ON THE FAULT LEVEL SETTING OF 45KA.I WOULD LIKE TO FIND OUT 25KA ENOUGH KA. APPRECIATE IF SOMEBODY CAN ASSIST ME WITH FORMULA FOR THIS. FRM: JEFF
Is there a diode made that works with AC 120 volt 20 amp? If so can it completely stop all current flow in 1 direction at all times?