Interested to Buy Any Domain ? << Click Here >> for more details...
what happen if power factor goss to above unity (one) ? of
any electrical system or motor.
- 10 Answers
- 23683 Views
- Air Liquide, I also Faced
- E-Mail Answers
Answer Posted / bhuvan sharma
if the power factor will increase more than unity thats mean current will drawn in the machine will be increase therefore due to the increase in current looses will be increase and supposed if we gonna get 80 % power at the o/p dn we get 70-75 %.
| Is This Answer Correct ? | 1 Yes | 4 No |
Post New Answer View All Answers
in the directional overcurrent and earthfault protection,normally we are setting the angle 45 deg lead for phase fault overcurrent and -45 deg lead for earthfault fro forward direction.but both the fault are operating on the same angle region only.why?how the relay will response?
What is VCB? where it is installed at SP. What is SP?
what are factors to be consider in electrical installation like load factor,diversity factor .....
why do we use spark detector inside the slip ring brush compartment 0ona slip ring induction motor?
What is the unit audit? if our Max demand is something and we found much more unit then how to improve our max demand?
What is evaporator & condencer & compressor
why Current is lead 90 degree and voltage is lag 90 degree in a capacitor.? why Current is lag 90 degree and voltage is lead 90 degree in an inductor.?
how to remover corona effect and hysteresis losses from contactor
What is block diagram?
how much maximum load a 2 core (Single phase) 16mm aluminium wire can take ?
How to calculate the heat load for a electrical room
WHAT IS THE MEANING OF BALANCED / UNBALANCED IN STABILIZER TYPES.
How can I model an open-delta ground transformer for a network supplied by 4 unit GTG and power transformer in ETAP?
how can we calculate the ampacity of the electrical wire/cable. and what are the factors must be considered. pls. elaborate.
what is the main parts of transformer? how it is functioning? pls giv the ans briefly.
