Interested to Buy Any Domain ? << Click Here >> for more details...
Answer Posted / usman
there is no such thing that by increasing frequency we can decrease size of transformer , size mainly depends on its rating but there is a way to make size smaller but not too smaller . one of the guy gave the right answer that by increasing flux density one can decrease size.
the formula which he gave is absolutely right
if someone is interested i can give him further elaboration.
| Is This Answer Correct ? | 0 Yes | 0 No |
Post New Answer View All Answers
how to identify the cable quality and what is flame proof cable
What is reactive power and where it is used.
draw the restricted earth fault protection circuit install on power transformer and identify its parameters and draw C/C curve of it
What is real time power factor control panel(RTPFC)?
what is a reactive power? what is the relation with power factor?
How to find ampere on ht side for selection of cable size ???
1)what is the function of a frequency inverter? 2)If a few frequency inverter are connected onto a device network,what are the two setting that will ensure the frequency inverter work properly on the network. 3)whats is the name of the input sensor for weigher? 4)How to confirm that the load cellis faulty? 5)Describe briefly the steps to validate that the weigher is working properly? 6)Describe the procedure to validate the flowmeter accuracy? 7)Describe briefly the steps to validate that the tempreture sensor/transformer is working properly. 8)what is the adjustment that need to be done when you are calibrating the temperature transmitter ? 9)what are the safety measures to be taken before disconnecting motor for rewinding. 10)whats is the synchronous speed in rpm of typical 4pole 50hz motor? 11)whats is the formula for kw, ohm's law 12)if a 3phase motor is rated 3kw,415vac,what is it's rated ampere?
What will happened if the neutral of the (star connected secondry) Xformer disconnected? (if its Above KVA rated one)
A 7 storey building has a floor area of 35,000sq.ft on each storey. On the ground floor 11KV electrical sub-station is to be erected. A load of 3kw for every 400sq.ft (p.f is 0.8) is proposed for each floor. fire pump 7.5hp, water pump 5hp, lift 2 nos, each 10hp and 20shop load of each shop is 5kw. calculate a. load each floor b. total load of building c. L.T feeders for aech floor and from transformer to main. d. distribution diagram e. capacity of sub-station/capacitor bank f. line diagram
what is the terminal voltage of dc series generator running at rated speed at no load?
what is metering cum synchronizing panel and how it is used?
How phase to phase voltage comes 440V.
what is inter connected dc generator?
If short circuit ratio is high is it bad or good for a machine then tell the reason...
How earthing of switchgear system to be done.
