Interested to Buy Any Domain ? << Click Here >> for more details...
Why we use three phase world wide why not four phase or
five phase being used?
- 8 Answers
- 12698 Views
- I also Faced
- E-Mail Answers
Answer Posted / usman
in three phase configuration all of three phases are equally distant ,with respect to their angular position 120 degree apart, from each other and voltage b/w any two phases is equal viz designated by Vl_l and three phase configuration is balanced.
| Is This Answer Correct ? | 1 Yes | 7 No |
Post New Answer View All Answers
If the line voltage is reduced to 75% of its rated value then by what percentage current will reduce ?? 75% 25% 50% no change and why ?
on a three-winding transformer relationship delta-delta-star, on third winding why the relationship is a star? what are the advantages and disadvantages? Thank you and please help
Draw the vector diagram and condition for the following: 1) Dyn1 2) Ynd0 3) YnYn0
Differentiate between low pass, high pass and band pass filter?
How to decide CT & PT ratings for a given transmission line carrying some rated voltage?
Why does amplifier gain reduce?
If not into production, how far did you follow the design and why did not you see it into production?
Hi guys! Plz help me to answer the following questions. 1. What are the types of transmission line energy losses? 2. Why are the VLF are used some types of services? 3. What frequencies are used for reliable beyond the horizon terrestrial communication without repeaters? 4. To permit selection of 1 out 16 equi-probable, what is the number of bitis required? 5. What is the most common modulation used for telegraphy? 6. What is the multiplexing is used to increase the capacity of the optic fiber? Thanks
what happens to the water pump if ground water level is slowly decreasing?our water pump is varying from no-load full-load due to this problem
what is the use of permanent magnet generator in exciter
what is the basic construction diffrance between servo motor ans sqiralcage induction motor
what is the relative size of single and three phase?
why voltage form factor of PT are increase , when it is ecpected heigher spikes in system. how it is calculated.
plz tell me,ht and lt panel terminals in substations explain beiefly
what is per unit calculation?looking for simple and strong explanation thk u
